SURESHELL CARRIER AND RAIL FOR BEN M4 (6-SHELL,
I installed this on my Panzer M4. Fits perfect. I had to reuse the screws from the Panzer rail without the washers. I put lock thread on the screws. Looks really good and holds the shells great.
Mesa Tactical SureShell Aluminum Shotshell Carriers with Rail combine a shell carrier with a MIL-STD-1913 (NATO STANAG 4694) Picatinny rail that accepts optical, sights, lasers or accessories. These shotshell carrier/rail systems mount via a “saddle” style method (Remington shotguns) or by using the drilled and tapped holes on top of the shotgun’s receiver.
SureShell Aluminum Shotshell Carriers with Rail are machined from 6061-T6 aluminum and use Mesa Tactical’s innovative rubber friction retention system to firmly and reliable hold shells in place until needed. Four, six and eight shell configurations and multiple rail lengths available.
The Integrated Rail SureShell shotshell carrier design for the Benelli M2 Tactical, Benelli M4/M1014, Benelli SuperNova and Mossberg 500/590 platforms is radically different from the side mount designs. Instead of a stamped backing plate, the shell carrier yoke is attached to a machined bracket with an integral Picatinny (MIL-STD 1913) sight rail.
The design allows the ShotShell assembly to be installed on the top of the shotgun by taking advantage of the factory tapped Picatinny (MIL-STD 1913) rail holes.
With the Benelli shotguns, the shell carrier assembly is mounted directly onto the shotgun receiver. With the Mossberg platforms, a steel mounting cleat is first installed and the shell carrier is fastened to the cleat.
Factory shotgun forends, except “tactical” forends, often feature significant receiver overlap when the bolt is pulled back. These forends will need to be cut down or replaced with aftermarket “tactical” forends to be used with some SureShell shotshell carriers. Before you install a SureShell shotshell carrier, measure your forend’s receiver overlap and compare it to the furthest forward point of the shotshell carrier. Then cut any potential overlap or interference off the end of the forend with a miter saw or a rotary arm saw for a perfect fit.
I installed this on my Panzer M4. Fits perfect. I had to reuse the screws from the Panzer rail without the washers. I put lock thread on the screws. Looks really good and holds the shells great.
Great quality, perfect fit
Excellent, quality product, perfect fit. Thank you Mesa Tactical.
I have the H2O edition someone mentioned it left black marks on the receiver I found a simple solution went to Walmart fabric section bought a small piece of black felt cut it to match the rear of shell carrier attached it to carrier problem solved hope this helps anyone concerned with this
Good quality item. Fit well on my Benelli M4.
High quality easy install.
Do not buy. Not only are shells nearly impossible to place and remove from the carrier, the carrier left multiple permanent black marks on my Benelli M4.
Easy install. Great accessory for any shotgun.
well made product